C-Tecnics - A COMMERCIAL DIVING EQUIPMENT MANUFACTURER SPECIALIST

The Jok II is a CE-marked commercial diving recovery harness to permit recovery of a fully-kitted diver from the water in air diving or bell diving conditions. Lifting can be via a rear of neck 'D' Ring or with a spreader bar across the two front of harness lifting points. The under-leg straps are essential for diver recover

The high quality JOK JACKET provides one assembly containing the three features required when dressing a commercial diver in one easy-to-put-on waistcoat-style harness:

· Diver recovery harness

· Bail-out bottle holder

· Weight belt

The JOK JACKET utilises the world-renowned CE certified JOK Diver Recovery Harness which is load tested to 9000 Newtons on each lifting point, providing a 6:1 safety factor.

  The C-Tecnics Diver Recovery Block and Tackle is used in the recovery of a diver into the diving bell. It is a 6:1 advantage pulley system with an extended length of 6 metres – this is the estimated length from the top of the inside of the bell, through the bell trunking, to the base of the stage. 

  The C-Tecnics Spreader Bar has been designed specifically to distribute pull evenly between the two front lifting points on the Jok II Harness during a recovery situation. It helps avoid crushing of the diver's chest and permits a head-back lift of the diver to facilitate breathing. Design has been important as it is part of a 'lifting system' so it has been designed in profile cut stainless steel to avoid the need to test weld points, load tested and certified to 300 Kgs. 

 The original Hot Crabber commercial diver’s glove has been designed by C-Tecnics from commercial diver’s feedback.  Made using a high quality multitop glove with a neoprene gauntlet sewn on for extra comfort and compatibility with hot water suits. 

   The C-Depth has been developed for electronic diver depth monitoring in lightweight diving operations rather than using a pneumatic diving control panel. The system is ideal to give the supervisor a surface read-out whilst air diving using tethered scuba diving, which utilises a rope or rope/comms line. The system can also be used as a bottom profiler. 

 Designed for use with the C-Tecnics C-Depth Digital Depth Monitor and also the range of C-Vision systems, the depth transducer is used for measuring divers depths and can be incorporated into the divers umbilical bundle. A digital depth reading is provided to the surface controller. 

 These well-proven connectors are compatible with nearly all of the ‘marsh marine’ style connectors in common usage across the industry. Simple silicone lubricant will keep these connectors in good condition and assist with make and break. Available in 2, 3 and 4 pin male and female options 

 The Diver's Clearview Demister is a simple time-proven device which provides a hands-free method of keeping face ports of diving helmets and masks free of condensation during working dive